Aligning the machine is an additional difficulty in the slope alignment of the drilling arm.
It’s difficult to drill parallel holes, only with marks on the ground.
It’s nearly impossible to drill all holes to the same depth without any measuring system.
The manual measuring causes high operating expenses and is also a huge time factor.
If the boreholes are drilled in the wrong position, explosions may result in rockfall and a dirty break-off edge.
It’s difficult to drill all the holes in the same angle.
With MOBA’s MDS-1000 drilling system, you can prepare your blast with precisely measured, uniform drill holes and immediately increase your cost efficiency. Save yourself time-consuming manual measurements and drill absolutely parallel holes of the same depth and angle in just a few simple steps with the assistance system.
The high-end MDS-2000 drilling system from MOBA allows you to prepare your blast with precisely measured, uniform drill holes and increase your cost efficiency immediately. Save time-consuming, manual measurements and drill parallel holes of the same depth and angle in just a few steps using the assistance system. Thanks to extraordinary modularity, you can also benefit from cost- and time-efficient upgrades from a varied selection of additional components.